PT100 Temperature Sensor

• Before ordering, please note that all our products do not include tax, you need to declare your own tax!

• If you need to send UPS/Fedex/TNT/DHL, please contact us. We need to discuss the freight with you.

• Technical questions e-mail：support@trianglelab.net

• Sales questions e-mail：sales@trianglelab.net

• The trianglelab has always been concerned about product quality.We are developing products and working hard to improve the quality.We will not abandon our reputation because of many cheap products on the market.It is believed that only high quality products can ensure the quality of your work and bring safety to your work.

• Some of our products may be more expensive than others,but please believe in our quality and believe that you will not regret when you receive the goods.

PT100's are high temperature, high accuracy temperature sensors that you can now use on your V6 HotEnd instead of a thermistor or thermocouple. PT100's are able to measure higher temperatures than thermistors-upto 400degC, and are more accurate then both thermistors and thermocouples in general. Our PT100 sensors are also very easy to handle, being of a metal cartridge type construction that is secured with a set screw, no more fiberglass sleeving or clamping washer.
The PT100 sensor will not fit in the standard V6 Hotends, but can be used with V6, Chimera, Lite6, and Kraken by using the PT100 Heater Block available in the spares and extras section.
If you want the thermistor sensor that can fits on your hotend please click below.

https://duet3d.dozuki.com/Wiki/Connecting_PT100_temperature_sensors

Please be aware that a PT100 is not the same as a thermistor and unless your electronics explicitly supports RTD Sensing devices you will need an amplifier board.

The Ultimaker 2 uses PT100 sensors by default, and this sensor allows you to connect your V6 Hotend and Ultimaker electronics with no alteration to the electronics or firmware of the Ultimaker 2.