- Before ordering, please note that all our products do not include tax, you need to declare your own tax!
- If you need to send UPS/Fedex/TNT/DHL, please contact us. We need to discuss the freight with you.
- Technical questions e-mail：[email protected]
- Sales questions e-mail：[email protected]
-
The trianglelab has always been concerned about product quality.We are developing products and working hard to improve the quality.We will not abandon our reputation because of many cheap products on the market.It is believed that only high quality products can ensure the quality of your work and bring safety to your work.
-
Some of our products may be more expensive than others,but please believe in our quality and believe that you will not regret when you receive the goods.
To purchase a tax-included products, please click the link below：
https://trianglelab.aliexpress.com/store/1654223Trianglelab Ender-3/CR-10 3D Printer Upgrade Kit (Compatible with many similar models of 3D printers)▉CR-10S HOTEND Compatible: Compatible with CR-10S
Compatible with CR-10S -S5
Compatible with CR-10S -S4
Compatible with CR-10
Compatible with CR-10 -MINI
Compatible with CR-20
Compatible with CR-20 PRO
Compatible with Ender2
Compatible with Ender3
Compatible with Ender3 PRO
Compatible with TronXY X5S
Compatible with Tevo Tornado
Compatible with Alfawise U20
*13:100k Hisens 3950 1% up to 300°C for hotend "Simple ONE " &"Hotend "All In ONE"
#define TEMP_SENSOR_0 13
https://github.com/MarlinFirmware/Marlin/blob/1.1.x/Marlin/thermistortable_13.hRecommended slicer setting:retraction speed over 80MM/S
retraction length 2.5-4MM
If you are facing PLA clogging problem，please try the followings:
1. Increase the retraction speed. The speed may have being limited in the firmware try to change it. G-command "M203 E200"
2. Increase the extruder acceleration. check your firmware settings. G-command "M201 E9000"
3. Reduce the retraction length.it depends on your machine setup.
4. Increase the nozzle temperature by 5-10 degrees.
5. Do not install the 2 screws for support the heatblcok like the stock hotend on the CR-10 printer.
6. Make sure that there is no gap between the heatsink and the heat breaker.
Mini DDB Extruder X 1
BLUE PTFE TUBE 1M X 1
CR-10 HeatSink X 1
CR-10 Titanium alloy heat break X 1
CR-10 Heater Block X 1 (Silicone Socks Gift)
*Compatible 100K B3950 Thermistor OR 104GT-2 Thermistor
*0.4MM Nozzle (Brass Nozzle) X1
The following is the full version of the option, please pay attention to choose the correct voltage.
Thermistor (NTC 100K B3950) X 1 （Only Set 1 and Set 2）
Heater Cartridge(12v or 24v) X 1 （Only Set 1 and Set 2）
*We do not recommend installing the locking screw for the BLOCK. The screw will cause more heat to be transferred to the CR10 HeatSink, potentially affecting your cooling system.
*Please read the following list of explanations for each package carefully.SET 1 12V Upgrade Kit
SET 2 24V Upgrade Kit
SET 3 Simplify Upgrade Kit
Upgrade kit installation demo:High quality accessories detail presentation:
